10 steps is all it takes to get a GPRO V25 Pump put in place
Putting a GPI V25 Fuel Transfer Pump on a tank can be pretty easy. Just follow the steps below and you'll be good to go.
Installing a GPI V25 Fuel Transfer Pump Walkthrough
- Apply thread tape to all threads on bung adapters, hoses, pipes, etc.
- Install the suction pipe on the included bung adapter and extend the pipe to its full length
- Install bung adapter onto fuel tank and tighten tightly into place
- Install the V25 pump on top of the adapter
- Use a 4 mm hex wrench to attach the nozzle holder to the pump
- Add the o-ring the pump outlet
- Attach the hose to the hose adapter
- Attach the hose adapter to the pump using a 5 mm hex wrench
- Tighten the hose into place
- Attach your nozzle to the open end of the hose
Offerings covered by this post:
GPI V25 12V Fuel Transfer Pump Only (25 GPM) – V25-012PO
GPI V25 12V Fuel Transfer Pump, 1″ Manual Nozzle, 18′ Hose & Tank Adapter Mount (25 GPM) – V25-012MD
GPI V25 12V Fuel Transfer Pump, 1″ Auto Nozzle, 18′ Hose & Tank Adapter Mount (25 GPM) – V25-012AD